[VoIP] Mitel Smart-1 as Pulse to Tone Converter

[Donald Froula]

Perfect! This works with no dependency of the dial
tone settings in the PAP2. I see in the manual that it
will retry the connection if no dial tone detected,
but failed to see the utility in my case.

Don

--- Greg Blakely <greg at vyger.net> wrote:

> The default route in a SMART-1 is run by this
> command:
> 
> #80327##
> 
> The first three digits translate to "wait for
> precise dial tone", and
> the rest of it amounts to "dial the number and cut
> through."
> 
> If the precise dial tone has timed out, the SMART-1
> does not detect it,
> and **should** hang up and then re-seize the line,
> detect the dial tone,
> and then dial and cut through.
> 
> If this is not happening, it may be that the #803
> part of the sequence
> is missing...  
> 
> Something to check, anyway.
> 
> Greg.
> 
> PS.  I'm fairly good at programming SMART-1 dialers,
> since I installed
> them for a 0+ provider for about three years, back
> in the late 1980s and
> early 1990s.  I'm not an expert, by any means, but I
> can usually get
> them running.
> 
> > -----Original Message-----
> > From: voip-bounces at ckts.info
> [mailto:voip-bounces at ckts.info] On Behalf
> Of
> > Donald Froula
> > Sent: Thursday, November 02, 2006 1:11 PM
> > To: voip at ckts.info
> > Subject: [VoIP] Mitel Smart-1 as Pulse to Tone
> Converter
> > 
> > I received my Smart-1 the other day and, after
> some
> > head scratching over the manual and odd
> programming,
> > got it working (sort of) as a dial pulse to tone
> > converter in fromt of my ATA (a Linksys PAP2).
> > 
> > The problem is that the Smart-1 picks up the
> outgoing
> > phone line as soon as the phone goes off-hook. By
> the
> > time I rotary dial all the digits and the Smart-1
> cuts
> > through, the PAP2 ATA has already timed out to
> > reorder.
> > 
> > I can adjust interdigit timers in the PAP2 to wait
> > long enough after the first digit, but there is no
> > timer I can find to control the off-hook to
> reorder
> > timing.
> > 
> > Ideally, I'd like the Smart-1 not to pick up and
> dial
> > the outgoing line until it detects a pattern match
> on
> > the incoming digits. I've been through the manual
> a
> > few times, but can't see how this would be done.
> > 
> > Any help is appreciated.
> > 
> > Regards,
> > 
> > Don
> > 
> > _______________________________________________
> > VoIP mailing list
> > VoIP at ckts.info
> > http://lists.ckts.info/mailman/listinfo/voip
> > Project Web Page: http://www.ckts.info/
> > 
> 
> 
> 
> _______________________________________________
> VoIP mailing list
> VoIP at ckts.info
> http://lists.ckts.info/mailman/listinfo/voip
> Project Web Page: http://www.ckts.info/
> 
>