[VoIP] Cisco 3810

[Shane Young]

Name and Number are supported on the FXS.

Nothing is supported on the FXO.


This was typical of Cisco gear of the time.  Even in the modular  
routers, you had a VIC-2FXO (voice interface card 2 FXO ports) which  
didn't support callerid.

Later, the VIC-2FXO-M1 (I forget what the M1 means) did support callerid.

I haven't yet tested connecting an line to an FXO card on a D4  
connected via T1 to the 3810 to see if that supports callerid.

Possibly something to play with over christmas vacation :)


Quoting John Novack <jnovack at stromberg-carlson.org>:

> John Jones is the highest authority on the 3810, but I don't believe the
> FXO module in them supports CLID
> Not sure either if the FXS module sends CLID. IF it does, it is only the
> number.
>
>
> John Novack
>
>
> Nathan Watson wrote:
>> For those who are familiar with the 3810, do you
>> know if it can handle and pass-through caller-ID
>> (FSK) data? That is, if I wanted it to see CID on
>> a CO line, could it see that and send that info to
>> an extension?
>>
>> Thanks,
>>
>> Nathan
>>
>> _______________________________________________
>> VoIP mailing list
>> VoIP at ckts.info
>> http://lists.ckts.info/mailman/listinfo/voip
>> Project Web Page: http://www.ckts.info/
>>
>>
>
> --
> Dog is my co-pilot
>
> _______________________________________________
> VoIP mailing list
> VoIP at ckts.info
> http://lists.ckts.info/mailman/listinfo/voip
> Project Web Page: http://www.ckts.info/
>

--Shane
+1-821-7311 CNET

----------------------------------------------------------------