[VoIP] Asterisk-Adtran dial rate

[John Novack]

The X100 was intended for the US market.
Perhaps the combo of that and the VERY short loop is the problem
Incoming selectors and station lines off EM switches in the US don't 
seem to have that problem, unlike the item being discussed now with 
FXO's through a T1 circuit.

John Novack


Jonathan Kay wrote:
> This might be a complete red herring, but I thought I would throw it 
> into the arena.
>
> When we first set up Alan's Asterisk, with an x100p clone for the FXO 
> interface, wired to a Group selector.
> The pulsing was very erratic. It was as if the loop resistance was too 
> low, or some sort of back emf problem. The pulsing relay seemed to over 
> saturate, and hold on too long during the break pulses. To cure this, we 
> put a 50 ohm resistor in both legs of the pair.
>
> JonK
> _______________________________________________
> VoIP mailing list
> VoIP at ckts.info
> http://lists.ckts.info/mailman/listinfo/voip
> Project Web Page: http://www.ckts.info/
>
>   

-- 
Dog is my co-pilot