[VoIP] Switcher in training

[John Novack]

Frank Hansche wrote:
> Good afternoon, all.
>  
> I am in the beginning stages of building an Asterisk switch, then ultimately an legacy switch.  
>  
> I have an extensive background in electronics and computers, and I have worked in microwave radio as well as operating a medium sized System 75.  I've read the documentation on Asterisk and, combined with my System 75 knowledge, I feel pretty confident about putting up an Asterisk PBX/tandem.  When I start to put my legacy switch together, I will most likely reach out to the group for some help.
>  
> One question I do have is about crossbar switches.  Is there equipment available to build a small switch?  I live in a typical Northwest tract home, and floor load is an issue.  I don't know if my floor will hold a larger switch.  Any information will be most helpful.
>  
> Oh yeah, I was also in broadcasting as a DJ and broadcast engineer.  East Hill Radio is my other spot of electronic and computer insanity!
>  
> Thank you for reading!Frank Hanschewww.easthillradio.comSupport community radio! 
>   
Welcome to the group.
When you are up and running on CNET, give me a call
666-9900

As to XBAR, you are probably not going to find much there, unless you 
are lucky enough to stumble onto a hotel PBX, then you will run into the 
transport and floor loading issues.
Building a small SXS system is much more a possibility.
As others have mentioned, Phil McCarter, in Jefferson, OR is a 
possibility for a nearby source of materials.
He also has some ITEC electronic SXS equipment that is surplus to his 
needs/ ITEC isn't as nice visually, nor does it make all the nice switch 
sounds, but you could build either in a 23 inch rack less than 7 feet 
high that won't fall through your floor!

John Novack

-- 
Dog is my co-pilot