[VoIP] Display 10-Digit Caller ID on SIP Phones?

[Lee Spenadel]

I have an Asterisk 1.4 installation as well and my Polycom SIP phones
display only the 10 digit phone number. I'm not doing anything special with
my sip.conf file.

Lee

-----Original Message-----
From: voip-bounces at ckts.info [mailto:voip-bounces at ckts.info] On Behalf Of
Jonathan Taylor
Sent: Tuesday, February 26, 2008 10:40 AM
To: voip at ckts.info
Subject: [VoIP] Display 10-Digit Caller ID on SIP Phones?

I have an Asterisk 1.4 installation with a combination of SIP phones and
analog phones, connected to both a VoIP gateway and a POTS line.  Most of
the incoming calls come in though the POTS.

Incoming calls are displayed on the SIP phones (Cisco 7940) as
<num>@<address>, where <num> is the 10-digit phone number and <address> is
the IP address of my PBX.

Is there a way to configure the system (or the phone) to display only the
10-digit number?  That would reduce clutter on the display and allow other
phone functions to work more smoothly, IMO.

Thanks


_______________________________________________
VoIP mailing list
VoIP at ckts.info
http://lists.ckts.info/mailman/listinfo/voip
Project Web Page: http://www.ckts.info/