[VoIP] Asterisk Startup

[gijones@clear.net.nz]

There is always a better way.

In the Zaptel source directory where you did the make , "make install" etc 
if you do "make config" this will install the necessary startup files for 
the Zaptel hardware.
Then do the same in the Asterisk directory,  "make config" and this will set 
the Asterisk to be loaded everytime you start / restart the PC.

Then all you need do is login then  type "asterisk -vvvr" in a terminal 
window and that will connect you to the console.  At the end of the session 
at the CLI prompt just type "exit" that will drop you out of the CLI console 
but Asterisk will still be running.

Hope this helps.

Brent

----- Original Message ----- 
From: "Richard Lane" <richardlane at exemail.com.au>
To: "Voice Over IP Tandem for Analog Switches" <voip at ckts.info>
Sent: Friday, January 11, 2008 12:12 AM
Subject: [VoIP] Asterisk Startup


> Hi All,
>
> I have a technical question.
>
> How do I make asterisk load on startup. At the moment I need to logon to
> the box and run asterisk -vvvvc
>
> There must be a better way.
>
> Richard
> _______________________________________________
> VoIP mailing list
> VoIP at ckts.info
> http://lists.ckts.info/mailman/listinfo/voip
> Project Web Page: http://www.ckts.info/
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.516 / Virus Database: 269.19.0/1216 - Release Date: 9/01/2008 
> 10:16 a.m.
>
>