[VoIP] Linksys 3102/Linksys3000

[Ian Jolly]

I've been trying without luck to set up one of these devices (3102) to connect to my Asterisk.  I've got this far -

FXS port working without any problem .  I can dial in/out to/from a telephone connected to the FXS port.

FXO port - Grrrrrrrrrh !   

Currently I'm only interested in getting it such that the FXO accepts incoming calls from a line on my old Strowger exchange which puts out AC ringing.  When I call into the FXO from the line, the FXO answers and gives dialling tone but nothing beyond that. The call then drops out after a timeout.

In my sip.conf, I've got the following -

[3102FXO]
type=friend ;
host=dynamic
context=3102FXO
username=3102FXO
secret=700484
dtmfmode=rfc2833
disallow=all
allow=ulaw

At the CLI> it appears to be registering -

asterisk*CLI> sip show peers
Name/username                  Host            Dyn Nat ACL Port        Status
3102FXO/3102FXO            192.168.1.16     D   N          5061     OK (10 ms)

That seems to be OK so far. 

The problem appears to be in the ATA.

I've tried that various setting for the FXO and its dialplan in the '3102 FXO setup' suggested on various forums/wiki's when working to an Asterisk - but to no avail :-(

Basically I want it to route the incoming call to a single number on my Asterisk. 

Anyone any ideas?

Has anyone any setting for the Linksys 3000/3102 ATA when it is connected as per the 'ATA' model for connecting a 'heritage' switch as per  http://www.ckts.info/fx-model.pdf  ??

Ian Jolly

Ian Jolly