[VoIP] Linksys 3102/Linksys3000

[John Novack]

Ian Jolly wrote:
> I've been trying without luck to set up one of these devices (3102) to connect to my Asterisk.  I've got this far -
>
> FXS port working without any problem .  I can dial in/out to/from a telephone connected to the FXS port.
>
> FXO port - Grrrrrrrrrh !   
>
> Currently I'm only interested in getting it such that the FXO accepts incoming calls from a line on my old Strowger exchange which puts out AC ringing.  When I call into the FXO from the line, the FXO answers and gives dialling tone but nothing beyond that. The call then drops out after a timeout.
>
> In my sip.conf, I've got the following -
>
> [3102FXO]
> type=friend ;
> host=dynamic
> context=3102FXO
> username=3102FXO
> secret=700484
> dtmfmode=rfc2833
> disallow=all
> allow=ulaw
>
> At the CLI> it appears to be registering -
>
> asterisk*CLI> sip show peers
> Name/username                  Host            Dyn Nat ACL Port        Status
> 3102FXO/3102FXO            192.168.1.16     D   N          5061     OK (10 ms)
>
> That seems to be OK so far. 
>
> The problem appears to be in the ATA.
>
> I've tried that various setting for the FXO and its dialplan in the '3102 FXO setup' suggested on various forums/wiki's when working to an Asterisk - but to no avail :-(
>
> Basically I want it to route the incoming call to a single number on my Asterisk. 
>
> Anyone any ideas?
>
> Has anyone any setting for the Linksys 3000/3102 ATA when it is connected as per the 'ATA' model for connecting a 'heritage' switch as per  http://www.ckts.info/fx-model.pdf  ??
>
> Ian Jolly
>   
What does the 3102FXO context look like in extensions.conf??

Any clues when you do a sip debug on the ATA peer?

Is the ATA even sending anything to Asterisk, or is it waiting for input 
from the switch?
I am not familiar with this ATA either, so I may be way off base.

John Novack

-- 
Dog is my co-pilot