[VoIP] Linksys 3102/Linksys3000

[Jack Ryan]

Hi Ian,

Did you sort this out? I anwered it in a recent e-mail to you without
realising you had posted this question.

Its in the "Missing sound files" thread

Regards

Jack



On 23/01/2008, Ian Jolly <ian at uax.org.uk> wrote:
>
> I've been trying without luck to set up one of these devices (3102) to
> connect to my Asterisk.  I've got this far -
>
> FXS port working without any problem .  I can dial in/out to/from a
> telephone connected to the FXS port.
>
> FXO port - Grrrrrrrrrh !
>
> Currently I'm only interested in getting it such that the FXO accepts
> incoming calls from a line on my old Strowger exchange which puts out AC
> ringing.  When I call into the FXO from the line, the FXO answers and gives
> dialling tone but nothing beyond that. The call then drops out after a
> timeout.
>
> In my sip.conf, I've got the following -
>
> [3102FXO]
> type=friend ;
> host=dynamic
> context=3102FXO
> username=3102FXO
> secret=700484
> dtmfmode=rfc2833
> disallow=all
> allow=ulaw
>
> At the CLI> it appears to be registering -
>
> asterisk*CLI> sip show peers
> Name/username                  Host            Dyn Nat ACL
> Port        Status
> 3102FXO/3102FXO            192.168.1.16     D   N          5061     OK (10
> ms)
>
> That seems to be OK so far.
>
> The problem appears to be in the ATA.
>
> I've tried that various setting for the FXO and its dialplan in the '3102
> FXO setup' suggested on various forums/wiki's when working to an Asterisk -
> but to no avail :-(
>
> Basically I want it to route the incoming call to a single number on my
> Asterisk.
>
> Anyone any ideas?
>
> Has anyone any setting for the Linksys 3000/3102 ATA when it is connected
> as per the 'ATA' model for connecting a 'heritage' switch as per
> http://www.ckts.info/fx-model.pdf  ??
>
> Ian Jolly
>
> Ian Jolly
> _______________________________________________
> VoIP mailing list
> VoIP at ckts.info
> http://lists.ckts.info/mailman/listinfo/voip
> Project Web Page: http://www.ckts.info/
>